IOSD-Video Signal Output Port Description

From DJI Wiki
Jump to: navigation, search
iOSD-Mounting and Using Wizard
iOSD-Setup Wizard
Mounting Steps Connections IOSD-Three Position Switch Setting Video Signal Output Port Description Port Description
Using Wizard
Test Operation Instruction Power Voltage Channel Distance Aircraft to Home Height Control Mode
Fail-safe Mode Pitch Attitude Roll Attitude Attitude Line Flight Velocity GPS Satellite Video Input
Vertical Velocity

Video Signal Output Port Description

  • If you use wireless video transmission module AVL58 specified by DJI, connect through the bi-port cable as shown.

  • If you use your own module, please connect through the one-port cable according the pin description.
  • Channel Control:Control signal for the video transmitter channel number (CH1、CH2、… CH8). If your video transmitter does not support this feature, then ignore this pin.

Video and iOSD Output:make sure this is correctly connected. Positive Voltage of Battery:=BATT+,please check the input voltage of your own wireless video TX module, and make sure it is matched to the voltage of BATT, to prevent damage from your wireless video TX module.

Personal tools
Namespaces
Variants
Actions
Navigation
Phantom Series
A2 Series
WooKong-M Series
Spreading Wings Series
Aerial Gimbals
Handheld Gimbals
NAZA Series
Flame Wheel Series
Ace Series
WooKong-H Series
Other Products
In other languages
Toolbox