Phantom 2 series new firmware v3.08 and new hardware updates

From DJI Wiki
Jump to: navigation, search

The Main Updates of New firmware (v3.08)

a) Dynamic home point: when using a GPS-enabled mobile device and running the VISION app, the Home Point will automatically be reset to the location of the device every 2 seconds during flight.

b) Ability to change the Return to Home altitude added to the VISION app (ability to change this setting in the Assistant software remains).

c) Maximum operating area, based on remaining battery power and current settings, can now be displayed on the ground station map view. This area automatically expands or contracts when new flight plans are set.

d) The aircraft’s current longitude and latitude will be displayed on the VISION app’s radar. When using ground station, the longitude and latitude of each waypoint is also displayed as they are set.

e) New pre-flight checklist that reminds users of important considerations before flying added.

f) Battery cell warning added to the VISION app that alerts users if battery issues are detected. Browse battery cell warning history in the VISION app.

g) New auto-discharging feature to address the issue of fully charged battery swelled when it was stored for an extended period.

h) Battery cell damages detection feature added.

i) New battery cell balancing feature to extend battery life.

j) Maximum descent speed set to 0.6m/s when the aircraft’s altitude is less than 10m and descending automatically (for example in failsafe mode). The maximum speed of descent remains 2m/s in other flight conditions.

k) Propulsion system performance enhancements.

l) German, French and Japanese language support added to the VISION app.


Special Notes:

a) The dynamic home point is only available when using GPS-enabled mobile devices. Your aircraft will not be able to record a dynamic home point if you are using a mobile device without a GPS module (e.g. iPod).

New Hardware Supported:

  • New remote control for Phantom 2 and Phantom 2 Vision+

The upgraded remote control comes with many new features. A gimbal control dial, trainer port, built-in rechargeable LiPo battery with a capacity of

2000mAh, battery level LED indicators and throttle locking feature that holds the throttle stick in place when descending are all included. The new

remote control is compatible with the Phantom 2 Vision+ and Phantom 2.

Use DJI Lightbridge to control your aircraft or connect the remote control to your computer via the trainer port to run a simulation application and practice your flying skills.

Remote control.png

  • New propulsion system for Phantom 2 and Phantom 2 Vision+

New 2312 motors, 9450 propellers, and ESCs combine to give you greater thrust and control than ever before. You can load more equipment on your

Phantom, and achieve up to 200g/arm of extra thrust when using a 3S LiPo battery with this completely new system.

Use DJI Lightbridge to control your aircraft or connect the remote control to your computer via the trainer port to run a simulation application and practice your flying skills.

New propulsion system.png New propulsion system2.png

  • New compass module for Phantom 2, Phantom 2 Vision and Phantom 2 Vision+

A new, anti-static compass has been developed, with a protective shell to help shield it in any flight conditions.

New compass module.png

Personal tools
Namespaces
Variants
Actions
Navigation
Phantom Series
Inspire 1 Series
Zenmuse X5 Series
Matrice Series
Guidance Series
A2 Series
WooKong-M Series
Spreading Wings Series
Aerial Gimbals
Handheld Gimbals
NAZA Series
Flame Wheel Series
Propulsion System Series
Ace Series
WooKong-H Series
Other Products
Toolbox